 |
Eliminate Your Heat Issue, Keep Your Gear Working. |
       |
|
Talon Clip® Introduction
Malico’s Talon clip® is designed for easy heat sink installation. Each installation takes less than 5 seconds to complete. Talon clip’s advance technology can not only improve heat dissipation, but also reduce installation time and cost. Talon clip® has been employed by thousands of companies in worldwide. Talon clip®, an innovation solution that can provide ultimate performance for your thermal demand Talon Clip® Advantages Quick and Easy Installation, Re-Usable It is tool free, and takes less than 5 seconds to install the heatsink with cooler on chipset. It is very simple to take down, and can be reused over time. Time and Cost Savings Reduce assembly time lead to decrease in total cost. Prevent Looseness The Talon clip® can prevent heatsink from loosening caused by fan vibration or change in physical adhesive material cause by heat or aged. Ultimate Effectiveness IC chips usually will as molding compound or flip chip as a finishing. When heat sink attachment use high adhesive material to package or dies so they can be used in conjunction with conventional heatsinks. However, higher adhesive materials result in lower thermal conductivity. By using the Talon clips, phase change materials can be applied when packaging a molding compound or die in order to increase its heat dissipation also compensate micro-channel and roughness surface for both conjunctions. Flexibility for PC Board/IC designs When designing PC boards there are areas that need to be reserved for heatsinks’ such as drilling holes or anchors soldering. With Talon clip®, designers will not need to reserve any drilling holes or anchors soldering during their circuit designing..
|
Copyright © 2009 Malico Inc. All trademarks or registered trademarks are the property of their respective holders. |